Toro Consumer 55-7930 Edger Blade, 10"
0.52 lbs.
Description...
Hide
When installing a new Blade, or Cutter, you may notice that the cutting edge has been pre-sharpened but then painted over. This paint is a safety measure to protect the installer from injury during installation. This paint will come off quickly during initial operation and should not be otherwise removed. In the case of a Sickle Bar Tooth or Hedge Clipper Blade, these are not usually painted and the cutting edges are very sharp. Please handle all blades with extra caution during installation.
Often Bought with this Part
Models that Use this Part
Your part was not found on any models.
- If you feel this is in error or desire further assistance, please call us!
58430 - Toro Edger, 3.5hp (SN: 006000001 - 006999999) (1986)
ENGINE & BLADE ASSEMBLY
58430 - Toro Edger, 3.5hp (SN: 007000001 - 007999999) (1987)
ENGINE & BLADE ASSEMBLY
58431 - Toro Edger, 3.5hp (SN: 000000001 - 000999999) (1990)
PIVOT ARM ASSEMBLY
58431 - Toro Edger, 3.5hp (SN: 007000001 - 007999999) (1987)
PIVOT ARM ASSEMBLY
58431 - Toro Edger, 3.5hp (SN: 008000001 - 008999999) (1988)
PIVOT ARM ASSEMBLY
58431 - Toro Edger, 3.5hp (SN: 009000001 - 009999999) (1989)
PIVOT ARM ASSEMBLY
58431 - Toro Edger, 3.5hp (SN: 010000001 - 019999999) (1991)
PIVOT ARM ASSEMBLY
58432 - Toro 2-Cycle Edger (SN: 008000001 - 008999999) (1988)
PIVOT ARM ASSEMBLY
58432 - Toro 2-Cycle Edger (SN: 009000001 - 009999999) (1989)
PIVOT ARM ASSEMBLY
